StorageTek 9840 Product Manual page 188

SCSI Change Configuration Menu
Table 6-2. Menu Table—SCSI Configuration (Continued)
Options Notes
Drive Node World-Wide Name Submenu
Note: Firmware release level 1.30.111, and up, can create a "Custom" WWN as required for
special circumstances.
Make sure a Custom WWN is unique, and registered in Host interface software.
Unregistered or duplicate WWNs will cause Host interface anomalies.
Defaults to last saved selection.
H=xxxxxxxx, together with
H=xxxxxxxx
L=yyyyyyyy, comprise the
unique 64-bit WWN that identifies
L=yyyyyyyy
this specific drive.
Pressing
steady, starts the change mode.
The left-most hexadecimal digit
begins flashing and will
increment up one value with
each additional press of
Pressing
digit at displayed value (0-F), and
advances flashing to the next
digit. When the last digit is set, a
second press of
menu to next submenu. Pressing
Select
flashing.
Drive Node Custom/Normal WWN Submenu
Note: This submenu only appears if a Custom WWN is in use, or is being created.
Custom is default selection.
WWN Custom
Normal selection recalls the
WWN Normal
stored Normal WWN from the
drive EEPROM.
Currently, a password (use 500) is
required to save a new Custom
WWN, or to reset a Custom WWN
back to the stored Normal WWN.
Password requirement will not be
in future firmware releases.
Note: If valid password is not entered, change to the WWN will not be saved.
6-32
when all digits are
Select
Select.
sets the flashing
Menu
advances
Menu
restarts the left-most digit
Sixth Edition
Procedure
1. Press to start change mode;
Select
or, press to bypass.
Menu
2. Press to increment digit
Select
until desired value is displayed,
then press to set.
Menu
3. Repeat step 2 for each digit.
4. Press to advance to the next
Menu
submenu; or, press
restart change mode.
1. Press to invoke Custom
Menu
WWN, and advance to the next
submenu; or
,
2. Press to toggle option;
Select
then, press to reset WWN to
Menu
the stored Normal WWN, and
advance to the next submenu.
to
Select
95741