Table of Contents
Advertisement
9738 Library Attachment
CAUTION:
Equipment damage. Do not force the fiber-optic plug into the connector.
5. Connect the FC cable to the desired port on the rear of the tape drive (see the figure
below).
a. Port A is on the left side.
b. The connector is keyed so the cable can only be inserted one way.
6. Repeat Steps 3 through 5 if you will be using both ports of the drive.
7. Locate the metal port enclosure.
8. Route the FC cable(s) through the appropriate hole of the enclosure.
9. Fasten the metal enclosure to the drive with two screws.
Note: To maintain the agency verification status of the product, you must attach the FC
port enclosure when using FC drives.
1
3-14
1
C53815
C53816
Sixth Edition
1. Fibre Channel Cable
1. Mounting screw location (2X)
95741
Advertisement
Table of Contents
