Table of Contents
Advertisement
6. Connect the 457 mm (18 in.) daisy-chain cable (PN 310292001) from the second 68-pin
connector to the next drive, if applicable (see the CSL drive tray in the figure).
Note: Use a 343 mm (13.5 in.) daisy-chain cable (PN 10083616) for the manual-mount
drive tray.
7. Install a terminator (PN 10148003) on the device at the end of the SCSI bus.
8. Repeat Step 2 through Step 7 for all other CSL or drive trays.
4
3
4
3
5
9. Go to
"Power-On Rack" on page 3-52
95741
1. Drive tray (two drive installed)
2. CSL tray
1
3. SCSI daisy chain cable
4. SCSI terminator
5. SCSI cable to host
5
2
C53265
if you are only installing SCSI drive/CSL trays.
Sixth Edition
Rack-mountable Tray
3-51
Advertisement
Table of Contents
