Table of Contents
Advertisement
Table 6-1. Menu Table—Fibre Channel Configuration (Continued)
Options
Notes
Drive Node World-Wide Name Submenu
Note: Firmware release level 1.30.111, and up, can create a "Custom" WWN as required for
special circumstances.
When Custom WWNs are to be used, Port A, Port B, and Drive Node WWNs should
all be changed to designated Custom WWNs to meet special circumstances.
Make sure a Custom WWN is unique, and registered in Host interface software.
Unregistered or duplicate WWNs will cause Host interface anomalies.
Defaults to last saved selection.
H=xxxxxxxx, together with
H=xxxxxxxx
L=yyyyyyyy, comprise the
unique 64-bit WWN that identifies
L=yyyyyyyy
this specific drive.
Pressing
steady starts the change mode.
The left-most hexadecimal digit
begins flashing and will
increment up one value with
each additional press of
Pressing
digit at displayed value (0-F), and
advances flashing to the next
digit. When the last digit is set, a
second press of
menu to next submenu. Pressing
Select
flashing.
Drive Node Custom/Normal WWN Submenu
Note: This submenu only appears if a Custom WWN is in use, or is being created.
Custom is default selection.
WWN Custom
Normal selection recalls the
WWN Normal
stored Normal WWN from the
drive EEPROM.
Currently, a password (use 500) is
required to save a new Custom
WWN, or to reset a Custom WWN
back to the stored Normal WWN.
Password requirement will not be
in future firmware releases.
Note: If valid password is not entered, change to the WWN will not be saved.
95741
when all digits are
Select
Select.
Menu
sets the flashing
advances
Menu
restarts the left-most digit
Sixth Edition
Fibre Channel Change Configuration
Procedure
1. Press
to start change mode;
Select
or, press
to bypass.
Menu
2. Press
to increment digit
Select
until desired value is displayed,
then press
to set.
Menu
3. Repeat step 2 for each digit.
4. Press
to advance to the next
Menu
submenu; or, press
restart change mode.
1. Press
to invoke Custom
Menu
WWN, and advance to the next
submenu; or
,
2. Press
to toggle option;
Select
then, press
to reset WWN to
Menu
the stored Normal WWN, and
advance to the next submenu.
to
Select
6-21
Advertisement
Table of Contents
