5. Insert the bottom-back edge of the cartridge into the CSL input bin.
6. Slide the front edge of the cartridge into the CSL.
7. Slowly release the CSL spring-loaded bookend and ensure it touches the
loaded cartridges.
8. Check that all loaded cartridges are seated correctly.
Note: Ensure that cartridges are aligned vertically and horizontally within
Cartridge Unloading
Cartridges are ejected from the feed channel into the output bin
One to seven cartridges may be ejected into the CSL output bin.
Note: When unloading cartridges from the CSL output bin, ensure the spring-
To correctly unload a cartridge from the output bin, follow these instructions
and refer to
1. Move the CSL spring-loaded bookend to the left and hold it in this position
while unloading cartridges.
2. Grasp the cartridge(s) and tilt the cartridge back slightly.
3. Remove the cartridge(s).
4. Slowly allow the CSL spring-loaded bookend to touch the feed channel.
Note: Allowing the output or input bin bookend to slam into the feed
Figure 5-12. Cartridge Unloading
1. Output bin bookend
95741
the input bin and that the spring-loaded bookend is pressed firmly
against the cartridges.
loaded bookend does not slam into the feed channel.
Figure
5-12:
channel may cause drive errors.
1
Sixth Edition
CSL Cartridge Loading/Unloading
(Figure
C53662
5-12).
5-15