Table of Contents
Advertisement
Rack
CSL Tray Nuts and Nut Plates
Use the instructions below to install the CSL tray captive nuts (PN 3000517xx)
and nut plates in the vertical frame members of the rack:
1. Locate the vertical frame members at the front of the rack.
2. Determine which holes the captive nuts are installed in. The CSL tray uses holes 6 and 8
(counting down from the bottom edge of the upper spacer panel).
3. Place the bottom edge of the nut into the hole, use a tool to push down on the upper
edge of the nut, push the nut into the hole (see figure below), and remove the tool.
4. Loosely attach nut plates for tray slide rails using two screws (see figure and instructions
below).
Note: Do not fully tighten the screws. The tray slide bracket will be inserted between
the nut plate and the vertical frame member in a later step.
a. At the front side of the cabinet, insert a nut plate into holes 2 and 3 (counting down
from the bottom edge of the upper spacer panel) of both vertical frame members,
and secure it with two screws.
b. At the rear of the cabinet, insert a nut plate into holes 2 and 3 (counting down from
the bottom of the fan tray) of both vertical frame members.
3-32
1. Captive nut
1
E53256
Sixth Edition
95741
Advertisement
Table of Contents
