Table of Contents
Advertisement
SCSI Cables (Desktop/CSL)
The 9840 Tape Drive/CSL connects to a SCSI bus and supports only the
differential alternative.
Note: Term power is not supplied by the 9840 Tape Drive, it must be supplied
All host systems should have either the SCSI ports labeled or the international
symbols displayed (refer to
for that port.
Use the instructions below to install the SCSI cables to the desktop drive or
CSL.:
Figure 3-7. SCSI International Symbols
SINGLE-ENDED
CAUTION:
Maximum cable length. The maximum cable length for the differential
alternative is 25 m (82 ft). Make sure that the total cable length (including
all daisy-chain cables) from the host to the last device does not exceed
the maximum length.
1. Mark each cable with the drive position number and device address.
2. Route the cable(s) from near the host to the vicinity of the desktop drive.
Note: Do not attach either end of the cable(s) at this time.
95741
by the host bus adapter card.
Figure
Sixth Edition
3-7) to indicate the electrical configuration
DIFFERENTIAL
Desktop Units
C53371
3-23
Advertisement
Table of Contents
