Table of Contents
Advertisement
5. Loosely attach nut plates for tray slide rails using two screws (see figure and instructions
below).
Note: Do not fully tighten the screws. The tray slide bracket will be inserted between
the nut plate and the vertical frame member in a later step.
a. At the front side of the cabinet, insert a nut plate into holes 10 and 11 (counting
down from the bottom edge of the upper spacer panel) of both vertical frame
members, and secure it with two screws.
b. At the rear of the cabinet, insert a nut plate into holes 10 and 11 (counting down
from the bottom of the fan tray) of both vertical frame members.
6. If you will not be installing CSL trays, go to
2
95741
"Install Slide Rails" on page
1. Nut plate
2. Screws (2)
1
E53321
Sixth Edition
Rack
3-33.
3-31
Advertisement
Table of Contents
