Clean Fibre Channel Components
Fibre Channel GBIC
To clean a GBIC (giga-bit interface converter), refer to
Note: If GBICs are shipped or stored without a dust cover, clean the
1. Blow any dust from the ferrule and the ends of the GBIC using compressed
air by positioning the air nozzle approximately 50 mm (2 in.) away from the
connector and blowing for 5 seconds.
2. Clean inside the GBIC with a swab saturated with isopropyl alcohol if
necessary.
3. Repeat Step 1.
Figure 8-3. Fibre Channel GBIC
8-6
connectors before installing into a Fibre Channel environment.
Sixth Edition
Figure
8-3).
C53529
95741