Table of Contents
Advertisement
Dislodge a Stuck Tape
Table 7-1
These errors do not create an error message on the alphanumeric display. Refer
to
Table 7-2 on page 7-3
Table 7-1. Power and Service Indicators
power
(7,
Figure
On
On or flashing
Flashing while
action takes
place
Continuous
flashing
On
Dislodge a Stuck Tape
When you press the
unload function is electronically triggered, and the cartridge fails to eject, it
indicates that the tape cartridge is stuck or jammed within the carriage.
Note: See
7-2
explains error indications shown by the
for error displays and recovery instructions.
service
7-1)
(1,
Figure
7-1)
Off
Flashing after
dump
collection
Flashing or off
Flashing or off
On
switch (6,
Unload
"Jammed Cartridge" in Chapter 8, "Servicing the Drive,"
instructions to remove the cartridge from a drive.
See
"Jammed Cartridge" in Chapter 5, "Cartridge Scratch
instructions to remove the cartridge from a CSL.
Sixth Edition
and
power
Meaning
Action
Normal operation
No action necessary.
is occurring.
A 9840 Tape Drive
Perform an IPL.
error is detected.
If the problem
persists, contact
authorized service
personnel.
A 9840 Tape Drive
No action necessary.
error occurred.
If repeated power-on
Power-on and IPL
and IPL sequences do
sequences occur
not make the drive or
automatically.
CSL operational,
contact authorized
service personnel.
The 9840 Tape
Retry the power on
Drive failed the
and IPL procedure.
power on
If the problem
procedure; it
persists, contact
cannot exit the IPL
authorized service
mode.
personnel.
A 9840 Tape Drive
Perform an IPL.
failure occurred.
If the problem
persists, contact
authorized service
personnel.
Figure 7-1 on page
indicators.
service
7-1)or when the
for
Loader,"for
95741
Advertisement
Table of Contents
