Getting Started
This chapter describes only the most common manual operations. It includes
instructions on operating the drive, and how to use the drive. This chapter
contains:
•
"Basic Operations" on page 4-1
•
"Clean the Drive" on page 4-5
•
"Cartridges" on page 4-6
•
"Format a Diagnostic Dump Tape" on page 4-10
•
"Diagnostic Dump to Tape" on page 4-11
Note: Refer to
Basic Operations
This section provides instructions on:
•
"Power-on the Drive"
•
"Power-off the Drive" on page 4-2
•
"Place the Drive Offline" on page 4-3
•
"Place the Drive Online" on page 4-3
•
"View Drive Configuration" on page 4-4
•
"View Firmware Release Level" on page 4-4
Power-on the Drive
Note: Refer to
1. To apply power to a desktop unit and/or rack-mountable drive tray:
a. Make sure the power cord is connected to an AC source.
b. Set the
2. To apply power to a library drive power supply that has a
a. Make sure the power cord is connected to a library power strip.
b. Set
3. To apply power to a library drive power supply that does not have a
switch, connect the power supply power cord to a library power strip.
95741
Chapter 6, "Menu System,"
Chapter 5, "Cartridge Scratch Loader,"
on a CSL.
switch on the rear panel to ON.
Power
switch to ON.
Power
Sixth Edition
for all drive operations.
for instructions to power-
Power
4
switch:
Power
4-1