Table of Contents
Advertisement
Table 7-2. Error Displays and Instructions (Continued)
A non-write protected tape is
NT Ready U
in the process of a manual
unload.
Offline alternating with an
Offline
asterisk (*) indicates that the
*
drive or CSL is offline.
The drive or CSL is
Online
operational.
The power supply failed.
Power Fail
The drive or CSL is in read
Reading
mode.
All of the following
Ready A
conditions must exist:
• The loaded tape is a
• The VolSafe tape is write-
• The drive or CSL has the
Note: Refer to
"Cartridges" in Chapter 1, "Introduction,"
cartridges.
The loaded tape is file-
Ready F
protected.
A VolSafe tape is loaded into
a drive or CSL which has
VolSafe disabled.
Note: If the drive sensor is defective, all VolSafe cartridges will read Ready F.
If a VolSafe cartridge is loaded in a drive or CSL that does not support VolSafe
(downlevel code), FSC 4AF6 is displayed.
The loaded tape is not file-
Ready U
protected.
The drive or CSL is rewinding. No action necessary.
Rewinding
The new configuration cannot
Save Fails
be saved.
95741
VolSafe tape.
enabled (write-protect
switch unlocked).
VolSafe function enabled.
Sixth Edition
Dislodge a Stuck Tape
Wait until unload operation completes.
Operator discretion.
Note: Place drive or CSL Online for use
by the host.
No action necessary.
Replace the power supply.
No action necessary.
Operator discretion.
for more information on VolSafe
Operator discretion.
No action required to read the VolSafe
tape.
To append data to a VolSafe tape, enable
drive or CSL and ensure the write-protect
switch is unlocked.
Operator discretion.
Replace the drive or CSL.
7-7
Advertisement
Table of Contents
