Table of Contents
Advertisement
Table 6-1. Menu Table—Fibre Channel Configuration (Continued)
Options
Notes
Port A/B Hard Physical Address Submenu
Defaults to last saved selection.
xx is the hex display physical
PA=xx,ddd
address. ddd is the decimal index
into the ALPA table
(valid indexes are 000–125.
Engineering recommends that
Port A addresses be even
numbers and Port B addresses be
odd numbers
As you manually change the
decimal index digits (ddd), the
hex display (xx) automatically
changes.
Pressing
steady, starts the change mode.
The left-most d digit begins
flashing and will toggle between
0-1 (only valid values) with each
press of
the digit at the displayed value
and advances flashing to the next
digit. Each press of
increment the flashing digit up
one value (0-9 valid). Pressing
Menu
displayed value, and advances
flashing to the last digit. When
the last digit is set, pressing
advances menu to next submenu.
Pressing
change mode with left-most digit.
Port A/B Soft Physical Addressing Submenu
Note: Skip this menu if Hard Physical Addressing is being used.
Defaults to last saved selection.
Searches for a soft loop ID in
Soft PA LO
descending order (125 to 0)
Searches for a soft loop ID in
Soft PA HI
ascending order (0 to 125)
95741
Select
when all digits are
Pressing
Select.
Menu
will
Select
sets the digit at the
will restart the
Select
Sixth Edition
Fibre Channel Change Configuration
Procedure
1. Press
Select
or, press
Menu
2. Press
Select
until desired value is displayed,
then press
3. Repeat step 2 for each digit.
4. Press
Menu
submenu; or, press
restart change mode.
sets
Menu
1. Press
Menu
2. Press
Select
then, press
advance to the next submenu.
to start change mode;
to bypass.
to increment digit
to set.
Menu
to advance to the next
to
Select
to bypass, or
to toggle option;
to set, and
Menu
6-15
Advertisement
Table of Contents
