Fault Symptom Codes; Table 5-6. Csl Fscs - StorageTek 9840 Product Manual

Error and Recovery

Fault Symptom Codes

Perform the following sequence of checks if a CSL error occurs.
1. Check the CSL
or on solid (failure). Clear the obvious error.
2. If the CSL does not indicate any problems, check the FSC list
3. Check sense data at the host for any FSC in addition to the information
provided in
Note: Some malfunctions are caused by communications errors between the
Table 5-6

Table 5-6. CSL FSCs

FSC
4E04
4E05
4E0C
4E0D
Note: The 4E0D FSC may occur after a cleaning cartridge has been
4E11
5-28
indicator to see if it is flashing (operator summoned)
operator
Table 5-6.
CSL and the drive, and also by internal software. If the malfunctions
continue, force a dump of the drive for engineering evaluation.
provides the 4EXX FSCs, suspected malfunction, and possible fix.
Malfunction
Cartridge installed incorrectly (180
degrees out, cartridge reels to left).
Drive replaced within the CSL, and
4E04 displays when cartridge is
loaded.
SCSI load command rejected due to
no CSL being attached to the drive.
SCSI load command cannot be
performed. The CSL is not in the
System mode.
SCSI load command cannot be
performed. There is no cartridge in
the input bin or feed channel.
unloaded.
ESCON load command is rejected
due to no CSL being attached to the
drive.
Sixth Edition
(Table
Fix
Insert cartridge correctly.
Install cartridge with reels to
the right. See "Recovery
Process" on page 5-25.
Drive may not be aligned
correctly within CSL. Have a
qualified technician remove,
replace, and align the drive.
Check the black control cable
between the drive and CSL.
Final action: have a qualified
technician replace the drive.
Select the System mode.
Load cartridge.
Have a qualified technician
check the black control cable
between the drive and CSL.
Final action: have a qualified
technician replace the drive.
5-6).
95741