Table of Contents
Advertisement
Table 7-2. Error Displays and Instructions (Continued)
The tape format is
CodUpFail3
unreadable.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx.
This is not a code-update
CodUpFail4
tape.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx.
Unable to create (format) a
DatCrFail1
data tape.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx.
Unable to create (format) a
DmpCrFail1
dump tape.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx.
The tape format is
DmpCrFail2
unreadable.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx.
The dump or event log is
DumpToHost
being transferred to host; the
operator panel switches are
locked
Unable to write a dump to
DmpWrFail1
tape.
Unable to position on tape.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx.
No dump to process.
DmpWrFail2
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx.
The drive or CSL detected the
DumpAgain?
same "CHK (xxxx)" within
one minute.
The cleaning cartridge is used
Exp ClCart
up.
95741
Reclaim as a data tape, recreate code tape.
Retry the operation.
Try another tape.
Retry with the correct tape.
Make sure the tape is write-enabled.
Try another drive or CSL.
Make sure the tape is write-enabled.
Try another tape.
Try another drive or CSL.
Reclaim as a data tape.
Retry the operation.
Try another tape.
No action necessary.
Try another tape.
Make sure the tape is formatted for a
dump.
Force a diagnostic dump.
Go to
"DumpAgain? Indication" on
page
7-12.
Replace the cleaning cartridge.
Sixth Edition
Dislodge a Stuck Tape
7-5
Advertisement
Table of Contents
