Table of Contents
Advertisement
UnWr xxxx Indication
UnWr xxxx Indication
nWr xxxx means Unwritten Data. This message will display if the
U
switch (6,
indicates that the drive attempted to write the remaining data before it unloaded
but the attempt failed and some data remains unwritten to tape.
CAUTION:
Pressing the
The host may save the unwritten data by issuing the following command
sequence before pressing the
Data."
DumpAgain? Indication
The "DumpAgain?" display alternates with a "CHK xxxx" fault symptom code
indication while the
occurs when the identical "CHK xxxx" fault symptom code is detected within
one minute. The drive then becomes non-operational and requires manual
intervention.
With this condition, you may choose to initiate a dump but there is no
requirement to do so. If you have reason to initiate the dump, press any control
except the
the EEPROM.
While the dump is being saved to the EEPROM, the
and the display alternates between "SavingDmp" and the "CHK xxxx" display.
After saving, the drive automatically performs an IPL.
Use the procedures in
EEPROM to tape or a file.
If you do not want to initiate the dump, press the
IPL of the drive without copying the dump data to EEPROM.
If the IPL fails, as indicated by any error message, replace the drive.
If the IPL is successful, continue with normal operations.
7-12
Figure 7-1 on page
7-1) was pressed during a write operation. It
switch again will cause loss of this data.
Unload
Unload
indicator (1,
service
switch (2,
Figure 7-1 on page
IPL
Chapter 4, "Getting Started,"
Sixth Edition
switch a second time: "Recover Buffer
Figure 7-1 on page
7-1). This saves the dump data to
service
to copy the dump data from
switch. This initiates an
IPL
Unload
7-1) flashes. This
indicator goes out
95741
Advertisement
Table of Contents
