Table of Contents
Advertisement
Mount Message
When the CSL receives a mount message from the host, one of the following
occurs:
• If the drive is empty and the feed channel contains a cartridge which hasn't
been previously loaded, the cartridge loads into the drive.
• If the drive and the feed channel are empty, but at least one cartridge is
available in the input bin, then the cartridge loads into the drive.
• Refer to
cartridge directly into the CSL.
Unload Message
When the CSL receives an unload message, the cartridge in the drive moves to
the feed channel. The CSL sequences as follows:
• If the output bin is not full, the cartridge is placed into the output bin.
• If the output bin is full, the cartridge remains in the feed channel, and the
operator
is pressed.
Note: Refer to
• If a mount has been pre-queued then, if possible, the next cartridge is
mounted with only one cartridge shift operation.
Place CSL in System Mode
1. Press the
2. Press the
3. Load up to seven cartridges in the input bin.
4. Press the
Note: The CSL does not respond to the
5. Unload the output bin when necessary.
95741
"Priority Mount Mode" on page 5-20
indicator blinks until the cartridge is removed and the
"Cartridge Removal from Feed Channel" on page 5-22
remove a priority mounted cartridge from the feed channel.
switch until the
Autoload Mode
switch to set the System mode.
Start
switch.
Start
the input bin of the loader.
Sixth Edition
Modes of Operation
to physically mount a priority
indicator illuminates.
system
switch if a cartridge is not in
Start
switch
Start
to
5-17
Advertisement
Table of Contents
