1. Power off the CSL if power is applied
2. Remove all cartridges from the input and output bins.
3. Locate the MUD screw within the CSL input bin (upper-left area).
Note: The CSL MUD screw is located to the right of the feed channel.
3
2
4. Obtain a long-common 1/8 in. screwdriver and insert it into the MUD slot.
5. Press against the spring-loaded MUD screw until it stops.
Note: Do not turn the screwdriver CCW when removing a jammed cartridge.
6. Slowly turn the screwdriver CW to remove the jammed cartridge (may take
approximately ten turns).
a. Turn the MUD screw until it will not turn any further. This action lowers the reel
motors within the drive.
95741
("Power On/Off CSL" on page
1. Mud screw
2. Input bin
1
3. Feed channel
C53667
C53668
Sixth Edition
Jammed Cartridge
5-12).
5-31