Table of Contents
Advertisement
Power On/Off CSL
Power On/Off CSL
This section provides a process to power on/off the CSL.
locations of the
interface.
Note: The CSL
Figure 5-9. CSL Power
1. Power switch
2. Power cord
3. SCSI cable
4. Terminator
Power On
1. Ensure the power cord is attached to the receptacle on the rear of the CSL.
Note: The power cord and applicable interface cable (SCSI) should have been
2. If the power cord is not attached to the CSL, do the following:
a. Attach the female end of the power cord to the CSL receptacle.
b. Attach the male end of the power cord to a power outlet.
3. Press the
4. Verify that the CSL powers on.
Note: A steady asterisk on the operator panel indicates a successful IPL
5-12
switch, power cord, terminator, and cable for a CSL SCSI
Power
Power
switch and power cord are located on the rear of the
CSL. The switch and cord are in the same locations on a SCSI or Fibre
Channel CSL.
4
3
attached during initial installation.
switch on the rear of the CSL to ON (1).
Power
completion, the drive is online, but not loaded with a cartridge.
Sixth Edition
Figure 5-9
1
2
C53661
provides
95741
Advertisement
Table of Contents
