Table of Contents
Advertisement
Table 6-2. Menu Table—SCSI Configuration (Continued)
Options
Notes
Data Security Erase Mode Submenu
Defaults to last saved selection.
Full DSE Y writes a random
Full DSE Y
binary pattern on the media,
over-writing existing data, from
the point of an "Erase" command,
to the End of Tape.
Full DSE N writes data on the
Full DSE N
media that indicates valid data
does not exist beyond the point
of an "Erase" command.
Note: Manufacturing ships drive with the Full DSE Y option selected.
SCSI ID Submenu
Defaults to last saved selection.
SCSI ID x
Pressing
character is steady, starts the
change mode. The X character
begins flashing and will
increment up, one value with
each additional press of
Pressing
character at displayed value.
Establishes the SCSI ID of the
drive. The value range 0–7 is for
narrow (8bit) bus width, and
0–F is for wide (16bit) bus width.
Note: Manufacturing ships drive with the SCSI ID 6 address option selected.
SCSI Target Negotiation Mode Submenu
Defaults to last saved selection.
When Yes is selected, it allows
Targ Neg Y
the drive control unit to initiate
Targ Neg N
negotiations with the host to
clarify the SCSI transmission
speed, in case the host had not
done so.
Note: Manufacturing ships drive with the Targ Neg N option selected.
95741
when the x
Select
Select.
sets flashing
Menu
Sixth Edition
SCSI Change Configuration Menu
Procedure
1. Press
to bypass, or
Menu
2. Press
to toggle option;
Select
then, press
to set, and
Menu
advance to next submenu.
1. Press
to start change mode;
Select
or, press
to bypass.
Menu
2. Press
to increment
Select
until desired value is displayed,
then press
to set.
Menu
3. Press
to advance to the next
Menu
submenu; or, press
restart change mode.
1. Press
to bypass, or
Menu
2. Press
to toggle option;
Select
then, press
to set, and
Menu
advance to next submenu.
to
Select
6-27
Advertisement
Table of Contents
