StorageTek 9840 Product Manual page 185

Table 6-2. Menu Table—SCSI Configuration (Continued)
Options Notes
VolSafe Selection Submenu
Defaults to last saved selection.
When VolSafe Y is selected, a
VolSafe Y
password (Contact StorageTek
Technical Support) must also be
entered before VolSafe is enabled.
VolSafe N When VolSafe N is selected,
VolSafe is disabled.
Note: Manufacturing ships drive with the VolSafe N option selected.
Full Code Load Submenu
Defaults to last saved selection.
When FullCode Y is selected,
FullCode Y
all drive code images are
downloaded to the EEPROM. This
enables the drive to be used to
create a code tape with all images
which then could be used to
update other drives.
When FullCode N is selected,
FullCode N
only the specific code image for
the drive is downloaded to
EEPROM. This option allows
more EEPROM space for dumps
and event logs, but disables the
drive from creating code tapes.
Note: Manufacturing ships drive with only one code image, and FullCode N selected.
CodCrFail3 displays if you try to make a code tape from a drive with only one
image loaded. (Code release level 1.30.109 and up, displays CHK A738.)
To enable a drive to create code tapes, select FullCode Y, and load the desired
code release level from a valid source.
95741
SCSI Change Configuration Menu
Procedure
1. Press
2. Press
then, press
3. If applicable, press
password entry. The left-most
character begins flashing.
4. Press
desired character is displayed,
then press
5. Repeat step 4 for each character.
6. Press
submenu; or, press
1. Press
2. Press
then, press
advance to the next submenu.
Sixth Edition
to bypass, or
Menu
to toggle option;
Select
to set.
Menu
to start
Select
to increment until
Select
to set.
Menu
to advance to the next
Menu
to restart.
Select
to bypass, or
Menu
to toggle option;
Select
to set, and
Menu
6-29