Table of Contents
Advertisement
Install Host Interface Cables
The 9840 Tape Drive supports Fibre Channel and SCSI interfaces. This section
contains:
•
"Fibre Channel Cables (Desktop/CSL)"
•
"SCSI Cables (Desktop/CSL)" on page 3-23
Fibre Channel Cables (Desktop/CSL)
Use the instructions below to install the Fibre Channel cables:
CAUTION:
Cable damage. Fiber optic cables are easily damaged. Follow the
guidelines in
cables.
1. Mark each Fibre Channel cable with the device address and port.
2. Route the interface cable(s) from near the host, hub, or switch to the drive/CSL.
Note: Do not attach either end of the cable(s) at this time.
3. Remove the rubber port plug from the selected drive/CSL port and clean the port.
Note: If you are unfamiliar with the cleaning procedure, see
Components" on page
4. Remove the interface cable connector covers and clean the cable ends with wipes.
Note: If you are unfamiliar with the cleaning procedure, see
Components" on page
95741
Chapter 2, "Safety and Handling"
8-4.
8-4.
Sixth Edition
Desktop Units
to prevent damage to the
"Clean Fibre Channel
"Clean Fibre Channel
3-21
Advertisement
Table of Contents
