Table of Contents
Advertisement
Chapter 5 – Setting Up Hardware
Installing a SIM Card
Models with cellular capability have a micro SIM slot, you'll need a micro (3FF) SIM card from your network
provider.
Note:
-LNA3 models work on both Verizon and AT&T networks. The device detects the carrier based on
your SIM card.
To install the SIM card:
With the contact side facing down, align the notched edge as shown on the following image and slide the
SIM card completely into the SIM holder.
Removing a SIM Card
To remove the SIM card, push the SIM card in. The device ejects the SIM card.
Cabling the Device
To cable the device:
1.
Connect the Ethernet cable to the Ethernet port on the device and to your computer.
2.
Connect the power supply to the device's power jack and plug it into an electrical outlet. When the
operating system is fully loaded, the STATUS LED blinks.
Getting Started
After powering up your device, refer to the following sources for help configuring and using your device.
mPower Models
If your device uses the mPower platform, getting started information is in
available through your model's page at
mLinux Models
If your device uses the mLinux platform, getting started information is at
http://www.multitech.net/developer/software/mlinux/getting-started-with-conduit-mlinux/
®
Conduit
AP MTCAP-L4E1 User Guide for Europe
Arrow.com.
Downloaded from
https://www.multitech.com/brands/multiconnect-conduit-ap
SETTING UP HARDWARE
mPower Software Guide
(S000727),
19
Advertisement
Table of Contents
