Configuring Ip Rip On The Lan; Configuring Ip For The Remote Site Connection - 3Com OfficeConnect 3CP4144 Cli User's Manual

6-6 C 6: M
HAPTER ANUAL
Configuring IP RIP on
the LAN
Configuring IP for the
Remote Site Connection
S
ETUP
You can specify the subnet in one of two ways: a class or numerical designation. If
you specify a Class C subnet mask, for instance, this command will generate a
255.255.255.0 subnet value for you. If you specify the number of bits (to be set to
1), the acceptable range is 8-30. The network address is invalid if the portion of
the station address not covered by the mask is 0.
Defining a numerical subnet is useful when your value falls in between classes.
You can also omit the mask altogether; it will automatically be calculated from the
address.
To add an IP network over the LAN, use the command:
add ip network <network name>
address <ip address/mask>
frame [ETHERNET_II | SNAP]
You can obtain a list of all configured networks using the command list
networks. To only list IP networks, use list ip networks.
By default, the network is enabled when it is created. You can disable the
network using the following command:
disable ip network <network name>
You can delete a disabled network using the command:
delete ip network <network name>
The reconfigure ip network command can be used to modify an existing IP
network's address or frame type.
IP RIP is configurable on each LAN IP network. The OfficeConnect Remote 812
supports two versions of RIP, V1 or V2. You can also disable RIP completely.
To set enable/disable RIP or set the version to use for a particular LAN IP
network, use the command:
set ip network <network name>
routing_protocol [NONE | RIPV1 | RIPV2]
Other permutations of the set ip network command can be used to configure
advanced RIP features and policies.
In order to enable IP to be routed to a remote site, you must configure the
following items in the VC profile associated with the remote site connection.
You must enable IP routing in the profile
You must enter the remote IP address information
You must enter the local IP address information
To enable or disable IP routing in a VC profile, use the command: