Rip - 3Com WL-603 User Manual

108 C 5: C
HAPTER ONFIGURING THE

RIP

R
OUTER
RIP (Routing Information Protocol) - RIP allows the network administrator
to set up routing information on one RIP-enabled device (this Router),
and send that information to all RIP-enabled devices on the network.
Figure 85 RIP Parameter Screen
You can set up RIP independently on both LAN and WAN interfaces.
1 Check the Enable RIP checkbox.
2 Check the Enable Auto summary checkbox. Auto summarization sends
simplified routing data to other RIP-enabled devices rather than full
routing data.
3 Select the Operation Mode:
Disable — RIP is not enabled for the WAN or LAN interface.
■
Enable — RIP is enabled for the WAN or LAN interface. The router will
■
transmit RIP update information to other RIP-enabled devices.
Silent — RIP is enabled, however the Router only receives RIP update
■
messages, it will not transmit any messages itself.
4 In the Version field, select 1 or 2.
3Com recommends that you only use RIPv1 if there is an existing
RIP-enabled device on your network that does not support RIPv2. In all
other cases, you should use RIPv2.