Displaying And Debugging Cbq - 3Com 3033 Configuration Manual

3Com Router Configuration Guide Addendum for V1.20
The following is the rule for a policy to be applied in interface view.
A policy configured with various features (including remark, car, gts, af, ef, wfq,
and wred,) apply to a common physical interface and a virtual template interface
over MP.
The policy configured with TS (gts), and ef, af, wfq cannot be applied on the
interface as an inbound policy.
The sub-interface does not support ef, af, or wfq but supports TS (gts) and TP
(car). The policy configured with TS and TP can be applied on the sub-interface.
Note:
In the case of fast forwarding, CBQ is not supported.

1.2.7 Displaying and debugging CBQ

After the above configuration, execute display command in all views to display the
current class-based queue configuration, and to verify the effect of the configuration.
Table 1-26 Display and debug CBQ
Display class information configured on the
router
Display the configuration information of an
specified policy or a specified class in all
policies or all classes
Display the configuration information and
running status of an policy on a specified
interface
Display the configuration information and
running status of class-based queue on a
specified interface
Enable the debugging of a CBQ
1.2.8 Typical CBQ Configuration Example
A typical CBQ configuration simultaneously transmits multiple service data on the
serial interface and satisfies the demand in various service flows by CBQ.
The networking diagram is shown below, wherein the bandwidth of serial0 is 64K,
PC1 sends service flow 1 to PC3, PC2 sends a service flow 2 to PC4, and there is
also a voice service flow.
Operation
14
Command
display qos class [ class-name ]
display qos policy [ policy-name [ class class-name ] ]
display qos policy interface [ type number } [ inbound |
outbound ]
display qos cbq interface type umber
debugging qos cbq { af | be | ef | class } [ interface type
number ]