Replacing The Cmos Battery - Intel SR1630GP - Server System - 0 MB RAM Service Manual

8. Install the processor and the heat sink. For instructions, see
Processor" on page
9. Install the system memory. For instructions, see
10. Connect the data cables. For data cable routing information, see
on page
11. Connect the power cables. For power cable routing information, see
Routing" on page
12. Install the PCIe* Riser assembly. For instructions, see
Assembly" on page
13. Install the processor air duct. For instructions, see
Duct" on page
14. Install the server system cover. For instructions, see
Cover".
15. Plug all peripheral devices and the AC power cable into the server.

Replacing the CMOS Battery

Caution: The CMOS battery is NOT hot-swappable. Before removing or replacing the CMOS
battery, you must first take the server out of service, turn off all peripheral devices
connected to the system, turn off the system by pressing the power button, and unplug the
AC power cord from the system or wall outlet.
The lithium battery on the server board powers the RTC in the absence of power. When
the battery starts to weaken, it loses voltage, and the server settings stored in CMOS RAM
in the RTC (for example, the date and time) may be wrong. For a list of approved devices,
contact your customer service representative or dealer.
Warning: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the equipment manufacturer. Discard used batteries
according to manufacturer's instructions.
Advarsel: Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med
batteri af samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren.
Advarsel: Lithiumbatteri - Eksplosjonsfare. Ved utskifting benyttes kun batteri som anbefalt av
apparatfabrikanten. Brukt batteri returneres apparatleverandøren.
Varning: Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ
som rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens
instruktion.
Varoitus: Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan
laitevalmistajan suosittelemaan tyyppiin. Hävitä käytetty paristo valmistajan ohjeiden
mukaisesti.
72
40.
87.
87.
62.
35.
®
Intel
"Installing DIMMs" on page
"Installing the PCIe* Riser
"Installing the Processor Air
"Installing the Server System
Server System SR1630GP / SR1630HGP Service Guide
"Installing the
37.
"Cable Routing"
"Cable