Table of Contents
Advertisement
Check the following:
•
Is the power-on light lit? If not, see
•
Are any other front panel LEDs lit?
•
Have any of the fan motors stopped? Use the server management subsystem to
check the fan status.
•
Have your fans speeded up in response to an overheating situation?
•
Have your fans speeded up in response to a fan that has failed?
•
Are the fan power connectors properly connected to the server board?
•
Is the cable from the front panel board connected to the both the front panel board
and to the server board?
•
Are the power supply cables properly connected to the server board?
• Are there any shorted wires caused by pinched-cables or have power connector
plugs been forced into power connector sockets the wrong way?
Drive Activity Light Does Not Light
Check the following:
•
Are the drive's power and signal cables properly installed?
•
Are all relevant switches and jumpers on the drive set correctly?
•
Is the drive properly configured?
• Is the drive activity light always on? If so, the signal cable may be plugged in
incorrectly.
CD-ROM Drive or DVD-ROM Drive Activity Light Does Not
Light
Check the following:
•
Are the CD-ROM/DVD-ROM drive's power and signal cables properly installed?
•
Are all relevant switches and jumpers on the drive set correctly?
• Is the drive properly configured?
Cannot Connect to a Server
•
Make sure the network cable is securely attached to the correct connector at the
system back panel.
•
Try a different network cable.
•
Make sure you are using the correct and the current drivers. See
References" on page x
108
"Power Light Does Not Light" on page
for a link to the current drivers.
®
Intel
Server System SR1630GP / SR1630HGP Service Guide
106.
"Server System
Advertisement
Table of Contents
Need help?
Do you have a question about the SR1630GP - Server System - 0 MB RAM and is the answer not in the manual?
Questions and answers