Removing The Rack Handles; Figure 78. Removing The Rack Handle - Intel SR1630GP - Server System - 0 MB RAM Service Manual

Removing the Rack Handles

1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. If it is installed, remove the front bezel. For instructions, see
Bezel" on page
4. Remove the two screws holding the rack handle in place, and remove the rack
handle from the server system as shown in Figure 78.
5. Repeat Step 4 on the opposite side of the system.
6. (Optional) Install the front bezel, if desired. For instructions, see
Front Bezel" on page
7. Plug all peripheral devices and the AC power cable into the server.
®
Intel Server System SR1630GP / SR1630HGP Service Guide
iii.
28.

Figure 78. Removing the Rack Handle

29.
"Removing the Front
AF001204
"Installing the
"Safety
95