Table of Contents
Advertisement
Diskette Drive Activity Light Does Not Light
Check the following:
Are the diskette drive power and signal cables properly installed?
Are all relevant switches and jumpers on the diskette drive set correctly?
Is the diskette drive properly configured?
Is the diskette drive activity light always on? If so, the signal cable may be plugged in
incorrectly.
If you are using the onboard diskette controller, use the SSU to make sure that "Onboard Floppy"
is set to "Enabled." If you are using an add-in diskette controller, make sure that "Onboard
Floppy" is set to "Disabled." To run the SSU, see the SKA4 Baseboard Product Guide.
If the problem persists, there may be a problem with the diskette drive, baseboard, or drive signal
cable. Contact your service representative or authorized dealer for assistance.
Hard drive Activity Light Does Not Light
If you have installed one or more hard drives in your system, check the following:
Are the power and signal cables to the drive properly installed?
Are all relevant switches and jumpers on the hard drive and adapter board set correctly?
Is the hard drive properly configured?
NOTE
Front panel hard disk LED indicates SCSI devices: The hard drive
activity light on the front panel lights when a SCSI device controlled by the
onboard SCSI host controller is in use. This LED does not display
CD-ROM activity.
CD-ROM Drive Activity Light Does Not Light
Check the following:
Are the power and signal cables to the CD-ROM drive properly installed?
Are all relevant switches and jumpers on the drive set correctly?
Is the drive properly configured?
Is the onboard IDE controller enabled?
NOTE
Front panel hard disk LED indicates SCSI devices: The hard drive
activity light on the front panel lights when a SCSI device controlled by the
onboard SCSI host controller is in use. This LED does not display
CD-ROM activity.
Solving Problems
75
Advertisement
Table of Contents
