Drive Activity Light Does Not Light; Cd-Rom Drive Or Dvd-Rom Drive Activity Light Does Not Light; Cannot Connect To A Server - Intel SR1520ML - Server System - 0 MB RAM User Manual

•
Are the power supply cables properly connected to the server board?
•
Are there any shorted wires caused by pinched-cables or have power connector
plugs been forced into power connector sockets the wrong way?

Drive Activity Light Does Not Light

Check the following:
•
Are the drive's power and signal cables properly installed?
•
Are all relevant switches and jumpers on the drive set correctly?
•
Is the drive properly configured?
•
Is the drive activity light always on? If so, the signal cable may be plugged in
incorrectly.

CD-ROM Drive or DVD-ROM Drive Activity Light Does Not Light

Check the following:
•
Are the CD-ROM/DVD-ROM drive's power and signal cables properly installed?
•
Are all relevant switches and jumpers on the drive set correctly?
•
Is the drive properly configured?

Cannot Connect to a Server

•
Make sure the network cable is securely attached to the correct connector at the
system back panel.
•
Try a different network cable.
•
Make sure you are using the correct and the current drivers. See
References" on page xix
•
Make sure the driver is loaded and the protocols are bound.
•
Make sure the hub port is configured for the same duplex mode as the network
controller.
•
Make sure the correct networking software is installed.
•
If you are directly connecting two servers (without a hub), you will need a crossover
cable.
•
Check the network controller LEDs next to the NIC connectors.
94
for a link to the current drivers.
"Server System
®
Intel Server System SR1520ML User's Guide