Led Head - OKIDATA OF1000 Service Manual

3.2.02 LED Head

CAUTION
Do NOT touch the LEDs.
1. Perform this procedure:
3.2.01 .
2. Raise the document table (1).
3. Press the buttons (2) and raise the copy stacker (3).
4. Detach the cable (4).
5. Press the copy stacker out at positions (A) and release the tabs of the LED head (5).
6. Remove the LED head, being careful not to lose the ground clip (6).
NOTES:
The Cable: LED-PCNT runs from the LED Head to connector CN4 of the PCNT board. This is a
flat white cable.
INSTALLATION
The blue strip of the cable faces the top of the unit.
When installing a new LED head, set the LED Head Drive Time.
Service Handbook for details
Clean the LED head using the LED lens cleaner provided in the toner cartridge kit or use a lens
cleaning tissue and ethyl alcohol.
details .
P/N 56110801 LED Head
Service Guide OF1000
Chapter 3 Maintenance & Disassembly
.
Refer to Section 3.4 of this Service Handbook for cleaning
RSPL B.2.04
Refer to Section 3.3 of this
Page: 68