Stacker Cover And Led Head - OKIDATA OF2600 Service Manual

3.2.21 Stacker Cover and LED Head

1. Perform procedures
3.2.03
3.2.05
3.2.19
2. Open the copy stacker, by pushing the buttons.
3. Disconnect the flat cable from the PC connector.
4. Remove the LED head while spreading the retainer on the copy stacker.
5. Press inward on the two hooks until the copy stacker is free from the two reset levers.
6. Spread the copy stacker until its free from the lower base, then remove the copy stacker.
NOTES:
Be sure not to touch the lens portion of the LED head.
Under normal circumstances, the PC connector should NOT be removed from the LED head. If it is
removed, use caution NOT to lose the connector pins.
When the LED head is replaced, the LED Head Drive Time may need to be set.
of this Service Handbook.
When cleaning, refer to Module 3.4
P/N N/A Cover: Stacker B.2.05
P/N 53069002 Cover: Face Down Stacker (Assembly)
P/N 50104801 Tray: Stacker Cover Extension
P/N 51013801 Guide: Wire
P/N 56111202 LED Head Assembly
Includes the items listed below.
P/N 51014601 Contact: Ground Clip
P/N 56730201 Connector: PC
P/N 56629102 Cable: LED Head
Service Guide OF2200/2400/2600
(except when removing LED Head).
of this Service Handbook.
Chapter 3 Disassembly & Maintenance
RSPL
RSPL
RSPL
RSPL
RSPL
RSPL
RSPL
Refer to Module 3.3
B.2.05
B.2.05
B.2.05
B.2.05
B.2.05
B.2.05
B.2.05
Page: 139