Upper Feed Roller Assembly - OKIDATA OF1000 Service Manual

3.2.22 Upper Feed Roller Assembly

1. Perform these procedures:
3.2.01
3.2.15
3.2.20
3.2.21
2. Remove the three screws (1).
3. Remove the left (2) and right (3) ADF ground plates.
4. Rotate the bearings (4) as shown in Figure A.
5. Lift the feed roller assembly (5) straight up, and then slide it in the direction of Arrow B to
remove.
NOTE:
The upper feed roller assembly consists of the feed roller one, the Z28 gear, the ADF bearings,
and the compression washers. To replace of these parts, order the assembly.
Cleaning
Clean the upper feed roller assembly as necessary.
Handbook for cleaning details
Lubrication
Lightly lubricate the Z28 gear.
details .
P/N N/A Screw RSPL B.2.14
P/N 53344601 Plate: ADF Ground (Left)
P/N 53344602 Plate: ADF Ground (Right)
P/N 50406301 Roller: Upper Feed Assembly
P/N N/A Roller: Feed (1)
P/N N/A Gear: Z28 RSPL B.2.14
.
Refer to Section 3.5 of this Service Handbook for lubrication
RSPL B.2.14
RSPL B.2.14
RSPL B.2.14
RSPL B.2.14
Service Guide OF1000
Chapter 3 Maintenance & Disassembly
Refer to Section 3.4 of this Service
Page: 88