Transfer Roller - OKIDATA OF1000 Service Manual

Page: 113
Service Guide OF1000
Chapter 3 Maintenance & Disassembly

3.2.47 Transfer Roller

CAUTION:
Do NOT touch the transfer roller! Touching the transfer roller may cause incomplete toner
transfer, resulting in faded output.
Use extreme care when lifting the transfer roller. The left bearing will break if too much twist or
pressure is applied .
1. Power OFF the unit and detach the AC power cord.
2. Remove the image drum cartridge, with the toner cartridge installed.
3. Using a flat-blade screwdriver, wedge the blade between the transfer roller gear the the base
frame. Gently pry the transfer gear and roller from the well.
4. Use the screwdriver to support the transfer roller under its shaft.
5. Do NOT lift the roller more than an inch to access the gear and bearing.
6. Remove both the transfer roller gear (1) and bearing.
7. Remove the transfer roller (2).
NOTE:
Lubrication
Lightly lubricate the points where the transfer roller contacts either the frame or the bearings.
Refer to Section 3.5 of this Service Handbook for lubrication details .
P/N 51229001 Gear: Transfer Roller RSPL B.2.05
P/N 53342601 Roller: Transfer Roller RSPL B.2.05
P/N 53344501 Plate: Transfer Contact B.2.05
P/N 51607402 Bearing RSPL B.2.05
B.2.05
P/N 51010903 Strip: Anti-Static