Fuser Counter Reset - OKIDATA OF1000 Service Manual

4.8.03 Fuser Counter Reset

You must reset the Fuser Counter whenever the Fuser Unit is replaced. To reset this counter,
perform the following actions.
1. Press SELECT FUNCTION.
2. Press RIGHT ARROW
3. Press the "7" Key.
The following message will be displayed.
7: PRT. COUNTER CLEAR?
YES NO
4. Press LEFT ARROW.
5. Press the "3" Key.
6. Press LEFT ARROW.
The following message will be displayed
ARE YOU SURE?
7. Press LEFT ARROW
8. Press SELECT FUNCTION
Verify the counter has been RESET as follows.
1. Press SELECT FUNCTION.
2. Press RIGHT ARROW.
3. Press the "8" Key.
4. Press LEFT ARROW.
The contents of the counter will be displayed on the LCD for approximately four seconds.
5. Press STOP to exit the procedure.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
twice.
to reset the fuser counter.
to exit the procedure.
Service Guide OF1000
Chapter 4 Failure & Repair Analysis
Page: 187