4.8.02 Drum Counter Reset
You must reset the Drum Counter whenever the image drum is replaced. To reset this counter,
perform the following actions.
1. Press
SELECT
FUNCTION.
2. Press
RIGHT ARROW
3. Press the
"7"
Key.
The following message will be displayed.
7: PRT. COUNTER CLEAR?
YES NO
4. Press
LEFT ARROW.
5. Press the
"2"
Key.
6. Press
LEFT ARROW.
The following message will be displayed.
ARE YOU SURE?
7. Press
LEFT ARROW
8. Press
SELECT FUNCTION
Verify the counter has been RESET as follows.
1. Press
SELECT FUNCTION.
2. Press
RIGHT ARROW.
3. Press the
"7"
Key.
4. Press
LEFT ARROW.
The contents of the counter will be displayed on the LCD for approximately four seconds.
5. Press
STOP
to exit the procedure.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
twice.
to reset the drum counter.
to exit the procedure.
Service Guide OF1000
Chapter 4 Failure & Repair Analysis
Page: 186