Image Sensor Assembly - OKIDATA OF1000 Service Manual

3.2.34 Image Sensor Assembly

1. Perform these procedures:
3.2.01
3.2.09
3.2.15
3.2.16
3.2.20
3.2.21
3.2.25
3.2.26
3.2.32
2. Remove the four screws (1).
3. Detach the cable from the connector (2).
4. Remove the image sensor assembly (3).
NOTE:
The Cable: Image Sensor connects the image sensor to CN 3 of the PCNT board.
The assembly is made of the sensor, the sensor holder, the ground cable, and the screw. To
replace any of these parts, order the assembly.
Cleaning
Refer to Section 3.4 of this Service Handbook for cleaning details
Calibration
Refer to Section 4.5.02
P/N 50405901 Sensor: Image Assembly
P/N 56628302 Cable: PCNT - Image Sensor
P/N N/A Holder: Sensor
of this Service Handbook for CIS Calibration information.
RSPL B.2.13
RSPL B.2.13
RSPL B.2.13
Service Guide OF1000
Chapter 3 Maintenance & Disassembly
,B.2.17
.
Page: 100