Transmit Stepper Motor - OKIDATA OF1000 Service Manual

3.2.13 Transmit Stepper Motor

1. Perform these procedures:
3.2.01
3.2.09
3.2.11
3.2.12
2. Remove the two screws (1).
3. Disconnect the connector (2).
4. Remove the transmit stepper motor (3).
NOTE:
The PCNT-S Motor Cable connects the transmit stepper motor to connector CN 10 of the PCNT
board.
Lubrication
Lightly lubricate the gearing of the transmit stepper motor.
Handbook for lubrication details
P/N 56511101 Motor: Transmit Stepper
P/N 57001301 Cable: PCNT-S Motor
Service Guide OF1000
Chapter 3 Maintenance & Disassembly
Refer to Section 3.5 of this Service
.
RSPL B.2.09
B.2.17
Page: 79