Protocol Dump - OKIDATA OF1000 Service Manual

4.7.02 Protocol Dump

The Protocol Dump Report provides the service technician with a tool to analyze the control signals of G3
protocol transmissions and receptions. This report can be generated manually or automatically. In either
case, the SERVICE BIT (Technical Function #27) must be ON in order to print this report.
Manual Generation
1. Press SELECT FUNCTION.
2. Press RIGHT ARROW.
3. Press the "*" Key.
4. Press LEFT ARROW
5. Press STOP to exit.
Automatic Generation
1. Press SELECT FUNCTION.
2. Press COPY twice.
3. Press LEFT ARROW.
4. Press RIGHT ARROW.
5. Press LEFT ARROW.
6. Enter "02".
7. Press RIGHT ARROW
8. Press LEFT ARROW
9. Press SELECT FUNCTION
NOTE:
Once Technical Function #02 is set to ON, a Protocol Dump Report will be generated immediately after
each communication session.
until the desired setting (YES or NO) is selected.
to save the setting.
to exit.
Service Guide OF1000
Chapter 4 Failure & Repair Analysis
Page: 181