Fuser Counter Reset - OKIDATA OF2600 Service Manual

2.8.04 Fuser Counter Reset

General Information
Reset the Fuser Counter whenever the Fuser Unit is replaced.
Procedure
To reset this counter, perform the following actions.
NOTE:
The Service Bit (Okifax 2200) or the appropriate bit of the Service Parameter (Okifax 2400/2600) must be
set to ON to reset this
Okifax 2200
1. Press SELECT FUNCTION.
2. Press RIGHT ARROW twice.
3. Enter "8" from the numeric keypad.
4. Press LEFT ARROW.
The following message will be displayed.
1: TONER COUNT CLEAR?
YES ( ¬ ) NO ( ® 1-4)
5. Enter "3" from the numeric keypad.
6. Press LEFT ARROW.
The following message will be displayed.
ARE YOU SURE?
YES ( ¬ ) NO ( ® )
7. Press LEFT ARROW to reset the counter.
8. Press SELECT FUNCTION to exit the procedure.
Okifax 2400/2600
1. Press SELECT FUNCTION.
2. Press One Touch Key 28.
3. Enter "4" from the numeric keypad.
counter. (Refer to Module 2.9)
Service Guide OF2200/2400/2600
Chapter 2 Failure Analysis
Page: 104