Processor Subsystem Removal - NEC POWERMATE PROFESSIONAL - SERVICE MANUAL 05-1997 Service Manual

5-16 Repair

Processor Subsystem Removal

To remove the processor subsystem (CPU module and heatsink) from the system board,
proceed as follows:
1. Remove the system unit cover as previously described (see "System Unit Cover
Removal").
2. Remove the power supply as previously described (see "Power Supply
Removal").
Position the system unit on its side.
3.
4. Remove the heatsink support top bar from the support pins on the system board
(see Figure 5-19).
5. Press in on the CPU module clips (see Figure 5-19).
6. Carefully slide the processor subsystem up and out of the retention mechanism.
Figure 5-19 Processor Subsystem Removal