Pci Error Messages - NEC POWERMATE PROFESSIONAL - SERVICE MANUAL 05-1997 Service Manual

4-10 Maintenance and Troubleshooting
Message
Off Board Parity Error
Slave DMA Controller Error
Slave Interrupt Controller
Error
System Memory Size
Mismatch
Timer Channel 2 Error
Message
Bad PnP Serial ID Checksum
Floppy Disk Controller
Resource Conflict
NVRAM Checksum Error,
NVRAM Cleared
NVRAM Cleared By Jumper
NVRAM Data Invalid, NVRAM
Cleared
Parallel Port Resource
Conflict
PCI Error Log is Full
PCI I/O Port Conflict
PCI IRQ Conflict
PCI Memory Conflict
Primary Boot Device Not
Found
Table 4-2 System Error Messages
Description
Parity error in the installed expansion memory. The format is:
OFF BOARD PARITY ERROR ADDR (HEX) = (XXXX)
XXXX is the hex address where the error occurred.
Error in the slave channel.
Slave Interrupt Controller failed during POST.
The amount of memory on the system board is less than the
amount in CMOS RAM. Check for mismatched SIMM sizes.
(All SIMMs must be the same size within a bank.) Run Setup
(see Section 2).
Most systems include two timers. There is an error in timer 2.
Table 4-3 PCI Error Messages
Description
The Serial ID checksum of a Plug and Play card was invalid.
The diskette drive controller has requested a resource that is
already in use.
The ESCD data was reinitialized because of an NVRAM
checksum error. Try rerunning the ICU.
The "Clear CMOS" jumper has been moved to the "Clear"
position and CMOS RAM has been cleared.
Invalid entry in the ESCD.
The parallel port has requested a resource that is already in
use.
This message is displayed when more than 15 PCI conflict
errors are detected. No additional PCI errors can be logged.
Two devices requested the same resource, resulting in a
conflict.
Two devices requested the same resource, resulting in a
conflict.
Two devices requested the same resource, resulting in a
conflict.
The designated primary boot device (hard disk drive, diskette
drive, or CD-ROM drive) could not be found.