Table of Contents
Advertisement
3-34
Option Installation
4.
Connect the other end to the SCSI device.
NOTE: After powering on the system and SCSI
device, access the SCSISelect utility to set the
SCSI ID and remove the termination on the
SCSI adapter board (see Section 2 for
information on accessing SCSISelect).
Figure 3-30 Connecting a SCSI Cable
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the POWERMATE PROFESSIONAL - SERVICE MANUAL 05-1997 and is the answer not in the manual?