NEC POWERMATE PROFESSIONAL - SERVICE MANUAL 05-1997 Service Manual page 61

Floppy Interface
The Floppy Interface field enables the diskette drive interface connector on the system
board. This field can be either "Auto" detected or "Disabled." The default is "Auto."
USB Interface
The Universal Serial Bus (USB) Interface field configures the USB interface ports on the
system board. The options are "Enabled" or "Disabled." The default is "Enabled."
Serial Port (1 and 2) Interface
The serial ports 1 and 2 may be "Auto" detected or "Disabled." The default is "Auto."
"Auto" assigns the first free COM port.
The serial COM port and addresses are as follows. When an option is selected for one serial
port, the selection is not available for the second port.
T
Disabled
T
COM1, 3F8h, IRQ4
T
COM2, 2F8h, IRQ3
T
COM3, 3E8h, IRQ4
T
Auto (default)
Serial Port 2 IR Mode
The Serial Port 2 IR Mode field allows you to dedicate Serial Port 2 for Infra-red
applications. This field can be either "Enabled" or "Disabled." The default is "Disabled."
Parallel Port Interface
The parallel ports may be "Auto" detected or "Disabled." The default is "Auto." "Auto"
assigns the first free LPT port. The parallel port address options are as follows.
T
Disabled
T
LPT3, 3BCh, IRQ7
T
LPT1, 378h, IRQ7
T
LPT2, 278h, IRQ7
T
Auto
Setup and Operation 2-19