Guidelines For Windows Nt Installations; Driver Installation For The Windows 95 Operating System; Preparation - NEC POWERMATE PROFESSIONAL - SERVICE MANUAL 05-1997 Service Manual

T
Have ready an MS-DOS bootable diskette containing a
autoexec.bat
T
Perform the steps in the "Preparation" section before upgrading to the Windows
95 operating system.
T
Install the NEC 16X CD-ROM drivers before installing the IDE, video, or audio
drivers.
T
Install the PIIX3 IDE Drivers before installing the video or audio drivers.

Guidelines for Windows NT Installations

Follow these guidelines when preparing the system and installing drivers:
T
Have a spare diskette ready.
T
Bear in mind that the system will not be able to play audio CDs or
CD-I formatted CDs after the PIIX3 drivers are installed.

Driver Installation For the Windows 95 Operating System

The following procedures describe how to load the drivers for the Windows 95 operating
system.

Preparation

Perform the following procedure before installing the Windows 95 operating system and
before installing the drivers.
Insert an MS-DOS bootable diskette into drive A.
1.
2. Copy a config.sys
3. Add the following line to the
device=nec_ide.sys /D:MTMIDE01
4. Add the following line to the
MSCDEX.EXE /D:MTMIDE01 /M:10
5. Insert the PowerMate Professional Series Driver CD into the CD-ROM reader.
file.
NOTE: Perform the steps in the "Preparation"
section and install the PIIX3 IDE Drivers before
installing the video or audio drivers.
and an autoexec.bat
config.sys
autoexec.bat
Setup and Operation
config.sys
file from the system to the diskette.
file:
file:
2-49
file and an