Monitor Connection; Speaker And Microphone Connections; Monitor Signal Cable Connection - NEC POWERMATE PROFESSIONAL - SERVICE MANUAL 05-1997 Service Manual

Monitor Connection

1. Locate the monitor signal cable.
2. Connect the monitor signal cable to the VGA connector on the rear of the system
unit. Secure the cable with the connector screws.
3. Connect the monitor power cable to a properly grounded wall outlet.

Speaker and Microphone Connections

Connect the speakers and optional microphone to the system unit as follows:
1. Locate the speaker with the control knobs. This is the right speaker (see
Figure 2-4).
NOTE: Use the documentation that comes with
the monitor along with the instructions in this
subsection to set up the monitor.
Figure 2-3 Monitor Signal Cable Connection
Setup and Operation 2-3