Scsiselect Utility; Landesk Client Manager - NEC POWERMATE PROFESSIONAL - SERVICE MANUAL 05-1997 Service Manual

2-34 Setup and Operation
Update the BIOS from the BIOS flash diskette as follows.
1. Write down the Setup parameters currently set on the system.
Turn off the system.
2.
Insert the flash diskette in drive A, and turn on the system.
3.
4. When the flash upgrade menu appears, choose "Update Flash Memory Area from
a file."
5. When the menu asks you to enter a path/filename, use the arrow keys to select the
".bio" file, and press
The utility asks for a confirmation that you want to load the new flash data into
6.
memory. Select "Continue with Programming."
After the upgrade completes, remove the upgrade disk.
7.
Reboot the system and start the Setup program. Press <
8.
defaults. Then, use the copy of the Setup selections you made at the beginning of
this procedure to set the options.
See "NECCSD Bulletin Board Service" in the previous subsection for information about
using the bulletin board (available in the U.S. and Canada).

SCSISelect UTILITY

Select the SCSISelect utility at boot up. Press
information on the screen. When the BIOS information appears, you have gone past the
window and must reboot.
The SCSISelect utility sets termination. In addition, from the SCSISelect utility you can
perform the following:
T
format a new SCSI drive
T
configure the host adapter
T
set a new SCSI ID.
To set a new SCSI ID, select the SCSI Device Configuration menu. With the arrow keys,
select Send Start Unit Command. Change the unit ID number from no to yes.
The ID for the SCSI adapter board is 7 and the installed SCSI hard drive is 0.

LANDESK CLIENT MANAGER

LANDesk Client Manager is provided with the PowerMate Professional Series system.
.
Enter
Ctrl-A
> to reset the BIOS
F5
as soon as you see the SCSI utility