Tips For Operation; Operating Mode; Setup Mode; Information About Buttons And Symbols - MICRO-EPSILON colorCONTROL MFA-1 Instruction Manual

Operation and Settings
6.2
6.2.1
Operating mode is used to set the sensitivity level for normal or fine mode. It is also used to configure light/
dark switching. The terms normal and fine mode refer to sensor selectivity.
6.2.2
Setup mode is used to adjust setup help, timer, drop-out or pick-up delay options. The symbol
to indicate that the sensor is in setup mode. Press the SET button for 4 seconds to switch between the two
modes.
6.3
The symbol
pressed for more than 4 seconds, the symbol light goes out.
6.4
Two pre-set sensitivity modes are available, for high and normal sensitivity, to facilitate adjustments for the
task at hand.
Normal mode
For high contrast applications:
The
Fine mode
For high contrast applications:
The
colorCONTROL MFA-1

Tips for Operation

Operating Mode

Setup Mode

Information about Buttons and Symbols

lights up when a button is pressed. It indicates that input was accepted. If a button is

Teach-in

Position the sensor.
SET
Briefly press the button once.
t
LED lights up; setup is complete.
Position the sensor:
SET
Briefly press the button once.
t
LED lights up; setup is complete.
Δ
is blinking
Page 28