Setting Ethernet - Omron NSJ CONTROLLERS - 03-2008 Operation Manual

Communications Settings
8-6-4

Setting Ethernet

Note
156
To use Ethernet, select the Comm Tab from the System Menu and press the
Enable Button.
The setting items for Ethernet will be displayed on the right side of the screen.
Display and set the network address, node address, IP address, subnet mask,
and default gateway. The MAC address and IP address table displays are also
available.
After setting, press the Write Button.
Setting Ethernet Communications Conditions
Setting item
Network Add. Sets the network address
used for Ethernet communica-
tions.
Node Add. Sets the local node address.
IP address Sets the local IP address.
Subnet Sets the subnet mask of the
local node.
Default gateway Sets the IP router.
MAC address Displays the MAC address
(device-specific information to
identify each device con-
nected to the network.)
LAN SPEED Selects the method used to
set the Ethernet baud rate.
FTP Selects whether or not to use
the FTP server.
IP address table dis- Displays the node numbers
play and IP addresses of other
nodes connected to Ethernet.
Do not set the following values for the IP address.
Host ID with all bits set to 0 or 1 (e.g., 192.168.21.0).
Net ID with all bits set to 0 or 1 (e.g., 255.255.21.16).
Subnet ID with all bits set to 1 (e.g., 192.168.255.16).
IP addresses that begin with 127 (e.g., 127.35.21.16).
Function
1 to 127
0 to 254
0.0.0.0 to 255.255.255.255
(See note.)
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
Read-only
Automatic switch or fixed
10Base-T
Enable or disable
Read-only
Section 8-6
Settings